POWERCENTER™ IS TO BE
INSTALLED IN ACCORDANCE WITH UL
1838: STANDARD FOR SAFETY.
TRANSFORMER MUST BE GROUNDED IN ACCORDANCE WITH THE NATIONAL
ELECTRICAL CODE. ALWAYS DISCONNECT POWERCENTER™ FROM
AC POWER SOURCE BEFORE INSTALLING OR REMOVING ANY COMPONENT.
These instructions apply to Nightscaping® Powercenters™ models T-100-SS, T-150SS,
T-250SS,
T- 500SS, T-1000SS,
H3O-250SS, H3O-500SS,
H3O-1000SS.
1.
Checking to see what model of transformer
you have:
A.
Stencil name indicates size in volts
and watts of Powercenter™.
B.
Modular transformer has a blank modular
plate to the left of fustats secured to the transformer
with 4 #8 phillips head screws.
C.
If this plate is blank and no photocell
on Powercenters™ side (no contacts, terminals,
clock etc...) this indicates a standard SS Powercenter™
ready to accept any control module.
* To install any NS Control module remove standard Powercenter™ blank plate along with red jumper wire from terminal #1
and #2. (Save for future use).
Terminal #1 is connected to terminal #2 at factory using
a red jumper wire. Trouble shooting note....Should any
module/timing component fail, remove cover, disconnect
component wire and use any component wire as a jumper
between terminal # 1 and terminal #2--Powercenter™
now functions as a standard Powercenter™.
